Exact-model support links · general owner checks · content revised October 7, 2026

Samsung DW80B6060US owner checks

US-model filter, spray-arm, loading, detergent, supply, and external drain checks.

Coverage boundary

This page applies only when the complete rating-plate model matches DW80B6060US. A symptom does not prove that a part has failed. Use the regional manual and recall instructions when they differ.

Manufacturer record

What is specific to DW80B6060US

Samsung’s U.S. catalog identifies DW80B6060US/AA as a 44 dBA StormWash+ dishwasher with a third rack and AutoRelease door.

What this changes: Check loading and rack clearance before interpreting a wash result; use the /AA model when selecting a parts diagram.

Samsung U.S. appliance catalog (external) · checked September 30, 2026

Check result and next step

Do not treat AutoRelease opening as proof of a latch failure

Samsung's US catalog lists AutoRelease and a third rack for DW80B6060US/AA. Record cycle stage and load clearance before choosing a repair route.

Samsung DW80B6060US: what your observation changes
ObservationWhat it establishesNext action
Door opens during the documented AutoRelease stageThe feature may explain the opening.Compare cycle timing and AutoRelease settings with the /AA manual.
Poor wash changes with third-rack loadingRack and spray-arm clearance remain relevant.Correct obstructed loading, then compare a similar wash.
Door misbehaves outside that stage or a drain fault repeatsThe feature does not settle this separate complaint.Record when it happens and request Samsung diagnosis; confirm /AA for parts.

These branches are our interpretation of the linked guidance. They do not establish a failed component or a successful repair.

Check a used DW80B6060US before accepting it

Check AutoRelease door movement, rack travel, filter seating and visible hose connections.

Parts boundary: Confirm the parts diagram against the complete US suffix before ordering.

Keep a note for the service visit

Record the complete /AA label if present, third-rack clearance, filter and spray-arm state, and drain result.

This form is not submitted or saved. Copy the note before leaving.

For published safety notices, use the separate appliance notices guide. A notice must match the full model and serial range.

Tools for the supported checks

Confirm before acting

  1. Confirm the door-edge model label
  2. Disconnect power
  3. Inspect only manual-listed removable parts

Supported owner actions

  1. Clean and lock the filter
  2. Restore spray-arm clearance
  3. Correct an accessible hose or air-gap condition
Stop and arrange qualified service if:
  • Broken glass is hidden in water
  • Leakage is below the cabinet
  • The unit cannot be safely isolated

Verify after the check or repair

  1. Run a supervised rinse/drain
  2. Check underneath for leaks
  3. Confirm the code does not return

Manufacturer resources

Open the symptom diagnostic →