Exact-model support links · general owner checks · content revised October 7, 2026
GE AHTT06BC P1 and FL drain checks
GE ClearView P1 versus FL: right-side cap/filter-plug drain, SLEEP reset, level installation, and the point for pump service.
This page applies only when the complete rating-plate model matches AHTT06BC. A symptom does not prove that a part has failed. Use the regional manual and recall instructions when they differ.
Manufacturer record
What is specific to AHTT06BC
GE identifies AHTT06BC as a 6,100 BTU ClearView window air conditioner and provides its owner manual.
What this changes: Use the ClearView installation and drainage instructions for this model rather than assuming a conventional window-unit drain layout.
Check result and next step
P1, FL and installation level on GE ClearView
GE manual 49-5000634 Rev. 5 requires level installation front-to-back and side-to-side. It identifies P1 as a pump problem and FL as a full internal tray.
| Observation | What it establishes | Next action |
|---|---|---|
| P1 or FL appears | Use the ClearView indoor drain route. | Switch off and unplug. Catch water below the right-side drain, remove the cap and filter plug, then refit both. If safe, restore power and hold SLEEP for 3 seconds as GE specifies. |
| Code persists after the documented drain/reset | The manual directs pump service. | Stop repeated resets and contact GE with the code and drain result. |
| Water leaks indoors or the installation is unlevel | Support and level need checking. | Have the installation corrected safely; do not add conventional outward tilt or drill the pan. |
Check a used AHTT06BC before accepting it
Confirm ClearView-specific installation hardware and drainage against the exact GE installation instructions.
Parts boundary: Do not apply conventional window-unit pitch or drain assumptions to this ClearView design.
Keep a note for the service visit
Record Cool mode, set point, filter condition, visible indoor/outdoor airflow and the first wet location.
Tools for the supported checks
- Room thermometer
- Flashlight
- Soft brush
- Shallow water container and towels
Confirm before acting
- Confirm Cool mode and a lower set point
- Inspect the owner-serviceable filter
- Check visible airflow and level installation front-to-back and side-to-side
- Use the plug test/reset device exactly as labeled
Supported owner actions
- Clean the filter as directed
- Remove visible grille obstructions
- Correct only an installation issue covered by the owner instructions
- Water touches the plug or outlet
- The plug device trips again
- There is burning odor, sparking, or refrigerant odor
Verify after the check or repair
- Measure room temperature after a full operating period
- Confirm condensate leaves by the intended path
- Check for normal, unobstructed airflow